Inventory - Grizzly G0453W Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Box Inventory (Figure 7)
A. Planer (Not Shown) .................................... 1
B. Extension Wings ........................................ 2
C. Return Roller (15" Models Only) ................. 1
D. Dust Hood .................................................. 1
E. Handwheel ................................................. 1
F.
Handwheel Handle ..................................... 1
G. Foot Pedal Caster Assembly ...................... 1
H. Feed Rate "T" Knob M8-1.25 ..................... 1
I.
Hex Wrenches 3, 4, 5, 6mm .................1 Ea.
J. Hex Wrench 8mm (20" Models Only) ......... 1
K. Rubber Foot Assemblies ............................ 2
L. Cap Screws M8-1.25 x 60 (Rear Wheels) .. 2
Lock Washers 8mm (Rear Wheels) ........... 2
M. Cap Screws M8-1.25 x 50 (Foot Pedal) ..... 3
Flat Washers 8mm (Foot Pedal) ................ 6
Lock Washers 8mm (Foot Pedal) ............... 3
Hex Nuts M8-1.25 (Foot Pedal) .................. 3
N. Rear Wheels ............................................... 2
O. Table Lock Star Knobs (15" Models Only) .. 2
Included w/Straight-Knife Planers (Figure 8)
P. Knife-Setting Jig ......................................... 1
Included w/Spiral Cutter Planers (Figure 9)
Q. Spare Cutterhead Inserts ........................... 5
Torx Screws T-20 M6-1 x 15 ....................... 5
R. L-Handle Torx Wrench T-20 ....................... 1
S. T-Handle Torx Wrench T-20 ....................... 1
-14-
B
I
J
Qty
Figure 8. Knife-setting jig for straight-knife
Q
Figure 9. Spare cutterhead inserts and Torx
wrenches for spiral cutterhead planers.
G0453W/ZW–G0454W/ZW (Mfd. Since 05/16)
E
F
H
K
M
N
L
Figure 7. Box inventory.
P
planers.
S
C
D
G
O
R