Wifi Settings - Barco CSE-200 Installation Manual

6.9

WiFi settings

W
ARNING
About WiFi
A connection with the Base Unit can be made via a wireless connection. A fixed wireless IP address is used to establish the con-
nection.
The transmission power of the wireless signal can be reduced.
Image 6-14
WiFi settings
Changing the IP address will require a repairing of the Buttons used with this Base Unit.
IP address & subnet mask
1. Log in to the Configurator.
2. Click Wi-Fi & Network → WiFi Settings.
3. To change the IP address or subnet mask, click in the input field and enter the 4 octets of the new IP address or subnet mask.
Note: This must NOT be 0.0.0.0 for static IP-Address assignment.
Frequency band & channel
1. Select the wireless connection channel by clicking on the drop down box and selecting the desired channel.
The channels available in the list vary according to the regional version of your Base Unit. Re-pairing the Buttons is not required
when changing the frequency band or wireless connection channel.
2. Select the wireless connection frequency band: 2.4 GHz or 5 GHz by clicking on the drop down box and selecting the correct
band.
Note: Make sure your PC's wireless interface supports the 5 GHz band before selecting it on the Base Unit.
R5900023 CSE-200 11/04/2016
:
It is not allowed to operate the Base Unit outside its intended geographical region.
6. CSE-200 Configurator
37