Power Connector Cable - HP 14-an0XX Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the display (see
To remove the power connector cable:
1. Disconnect the cable from the system board (1).
2. Lift the tape and remove the cable from the clips around the fan (2).
3. Lift the power connector cable from the computer (3).
Reverse this procedure to install the power connector cable.
Battery on page 26).
Optical drive on page
Bottom cover on page
Display assembly on page
27).
30).
53).
Component replacement procedures
Spare part number
813505-001
61