Advertisement
Connections
There are seven built-in alarm inputs to use as internal alarm
triggers and two alarm built-in outputs in the camera housing.
These connections do not apply to the TVP-1122/3122
cameras.
Note: The DIP switches are not used.
Figure 2: Connections to the circuit board (excludes TVP-
1122/3122)
1.
Power supply: Connect +24 VAC power supply and GND.
2.
RJ45 connector: Connect to the network.
Caution: The RJ45 connector on the camera module is not for connecting the
network. It is an RS-232 port for troubleshooting.
3.
Alarm inputs 3 to 7: Connect to up to five alarm input devices.
4.
GND
5.
Alarm inputs 1 and 2: Connect to up to two alarm input devices.
6.
Alarm outputs 1 and 2: Connect up to two output devices
7.
AIN, AOUT: Connect audio input, audio output, and GND to the audio
terminals.
8.
VIDEO: Connect a CCTV monitor to the video terminals.
Alarm input and output connections
The alarm output can be used to turn on and off an external
alarm device. Connect a 30 VDC/1 A external power supply to
the alarm output. If using an AC power supply, an external
relay must be used to prevent electric shock and damage to
the device. See Figure 3 below.
Figure 3: External alarm output
Direct current:
Dome camera
relay output
Alternating current:
Dome camera
relay output
2 / 6
Installing a camera
Pendant-mount camera
1.
Prepare the mounting surface and install the camera
bracket.
2.
Unscrew the bubble from the camera and remove the
protective tape from the PTZ module (excluding TVP-
1122).
3.
Press the two tabs on either side of the PTZ module and
remove the module from the camera housing (excluding
TVP-1122).
4.
Route the cables from the pendant bracket as shown
below.
5.
Attach the safety cable to the bracket and connect the
cables to the PCB of the module through the cable entry
hole on top of the housing.
Safety cable
Note: If alarm and audio input/output relays are to be
used, also connect them to the PCB of the module.
Caution: The safety cable is made of metal. Please ensure
that it does not touch the PCB of the module.
6. Attach the camera housing to the bracket using the screws
enclosed with the bracket.
7.
Insert the PTZ module into the housing:
Position the tabs on the PTZ module by aligning the arrow
label on the module with those on the housing (see
below). The module should firmly snap into position. If
using a SD card, insert it into the module before inserting
the module into the housing.
P/N 1073029-EN • REV A • ISS 03JUN15
Advertisement
