Installing The Dome; Installing The Power Switch - Winegard roadtrip mission User Manual

Installing the Dome

Note: this is not required for DIRECTV Installation. This is only required if the
dome has been removed to change the switch settings (see page 3).
1 Place the RoadTrip Mission dome over the unit so that the decals on the
dome face away from the centerline of the vehicle.
2
Line up the holes in the dome with the holes in the RoadTrip Mission base.
3
Insert all of the dome screws, and tighten.

Installing the Power Switch

1 Choose a location to install the RoadTrip Mission power On/Off switch. When
selecting a location, remember that you will need to run the + 12VDC power
cable from the RoadTrip Mission antenna to the switch.
2 For a wall or panel mount, drill 1¼" hole, and pull wires through wall or
panel.
Figure 6
Steps 4 and 5
+12 V from vehicle
Steps 6 and 7
+12 V from dish
Be sure the switch is in the Off position before continuing. See Figure 6.
3
Connect the + 12V power wire from the vehicle to a small red flag connector.
4
5
Connect a small red flag connector to isolated spade on switch.
6 Connect the red wire from the antenna to the small red flag connector.
Connect the small red flag connector to the center spade on switch.
7
8
Slide the ground wire from the vehicle into one end of the barrel crimp
splice, and slide the black ground wire from the antenna into the opposite
end of the splice. Crimp the splice.
Continue to page 7 for DISH receiver setup or page 11 for DIRECTV receiver
setup.
Mission Antenna
On/Off Rocker Switch
(shown in Off Position)
Barrel crimp
splice
See Step 8
6