Toshiba MMY-MAP1006FT8(J)P-E Service Manual page 296

3. . TERMINAL-PW (TB03)
1 Detachment
1) Perform work of procedure 1. of 1 Detachment . (Electoric parts cover)
2) Remove the wires from the TERMINAL-PW (TB03).
3) Take off screws fixing the TERMINAL-PW (TB03). (φ4 x 14, 2 pcs)
2 Attachment
1) Fix the terminal assembly as before.
2) Fit the fixing screws (φ4 x 14, 2 pcs).
3) Connect the wires disconnected as before.
4) Attach the Electoric parts cover. (Refer to 1. of 2 Attachment)
4. . TERMINAL-2P (TB01, TB02)
1 Detachment
1) Perform work of procedure 1. of 1 Detachment . (Electoric parts cover)
2) Remove the wires from the TERMINAL (TB01 and TB02).
3) Take off the screws fixing the TERMINAL (TB01 and TB02).
(φ4 x 14, 1pc)
1) Fix the terminal assembly as before.
Fit the cylindrical protrusion of the terminal block (TB01 and TB02)
into the hole of the sheet metal of the electrical box.
2) Fit the screws (φ4 x 14, 1 pc)
3) Connect the wires disconnected as before.
For the leads of the coil (3 pcs) that has the faston terminal of the straight type on the edge,
connect each of them to any of the tab on the right side of the TERMINAL (TB02)(4 places).
(Refer to fig.A) For the leads of the coil (6 pcs) that has the faston terminal of the flag type on the edge
(one side) and the lead (1 pc) that has the faston terminal of the flag type on the both ends, connect
them to the TERMINAL (TB01). (Refer to fig.A) For the connection direction to the TERMINAL
(TB01) for the lead that has the faston terminal of the flag type , refer to the figure B.
Straight-Shape
Flag-Shape (both ends)
Fig.A
4) Attach the Electoric parts cover. (Refer to 1.-2)
Flag-Shape
lead upward
lead downward
Fig.B
− 295 −
Remove
from the
terminal.
Fit in the hole