Factory Default; Lamp Counter Reset - Eiki EK-100W Owner's Manual

(3) When DHCP is set On, IP address, Subnet,
Gateway and DNS will be obtained
automatically, press the OK at "Set" to confirm
the parameters.
When DHCP is set Off, press the OK button to
enter IP address, then press  button to enter
Subnet, Gateway and DNS respectively,
press the OK at "Set" to confirm the parameters.
 Note:
See page 53 for usage of Network.

Factory default

This function returns all setting values except
for the User logo, PIN code lock, Logo PIN
code lock, Lamp counter and Filter counter to
the factory default settings.

Lamp Counter Reset

This function resets the counter of Lamp usage
hours.Please be sure to reset the lamp counter
after replacing the lamp. WARNING indicator
turns Off and the lamp replacement icon disap-
pears after reset the lamp counter.
Press < MENU > button on the remote con-
troller or on the top control panel to display
the OSD menu. Press button to select the
Expand menu, then press <OK> or button.
1) Press button to select [Lamp counter]
menu.
2) Press <OK > button.
3) Press button to select [Lamp counter
reset], then press <OK> button.
4) " Lamp replacement counter reset ? "
conformation box appear.
5) Select "Yes" and Press <OK> button.
50
Expand
LAN
DHCP
IP address
Subnet
Gateway
DNS
Adjust
Factory default
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Lamp counter
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Network setting
Off
192 168 1 100
192 168 1 100
255 255 255 0
192 168 1 1
192 168 1 1
Set
Cancel
Select Back
Esc
ENTER