Defaults - Samick DCP-12 Manual

Defaults

Default Settings
The table below shows the piano factory default settings and whether or not user
changes to these settings are retained after a power-cycle (turning the device off and on):
Parameter
Program Number
& Voice Selected
Voice Button Bank Selection
Bank MSB Number
Bank LSB Number
Transmit Channel
Octave shift
Transpose
Local
Data Control Assignment
Data Control Value
(per assignment and only CC - not
including PGM or Bank LSB/MSB)
Velocity Curve Selected
Voice Volume
Metronome Volume
Master Tune
Tempo
Reverb On/Off
Reverb Depth
Reverb Type
Chorus On/Off
Chorus Depth
Chorus Type
Split Mode On/Off
Split Point
Split Mode Voice
Split Volume
Layer Mode On/Off
Layer Mode Voice
Layer Volume
At power-on, the following MIDI data will be sent to the sound engine, the USB
MIDI and the MIDI Out:
1. Bank Change MSB=0, LSB=0, PGM=0 - Set sound engine to piano voice
2. Reverb default value
3. Chorus default value
Factory Default
0
Off
0
0
00(channel 1)
0
0
On
Data = cc:007 Volume
Value of cc:007
NORMAL
100
127
0
120
Reverb On
Defaults for each sound
Defaults for each sound
Chorus On
Defaults for each sound
Defaults for each sound
Off
Eb3
8 - Upright Bass
127
Off
7 - Strings
100
41
Retained on Power-Down
No
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes - store for each sound
Yes - store for each sound
Yes - store for each sound
Yes - store for each sound
Yes - store for each sound
Yes - store for each sound
No
Yes
Yes
Yes
No
Yes
Yes