Panasonic CW-XC103VU Operating Instructions Manual page 6

5
ECONOMY OPERATION
ECONOMY
ECONOMY
ECONOMY
Recommended for electricity cost saving. When economy button is
pressed, target temperature is shifted up 1°F, this will reduce operating
time of the compressor and therefore reduce power consumption. It
may, however, take a little longer for the compressor to cycle on and
thereby increase the room temperature slightly. Economy mode will
override your current set fan speed to "LOW". However, the display will
still show the current set fan speed. Compressor stops when the room
temperature reaches the target temperature. It turns on again when
the room temperature rises. When power failure occurs, the economy
setting is canceled. Once power is resumed, reset the economy setting.
SETTING THE OFF TIMER
TIMER
TEMP/TIMER
SET
SET/
CANCEL
TIMER
TEMP/TIMER
SET/
CANCEL
CHECK TIMER SETTING DURING OFF TIMER
TIMER
TIMER
CANCEL TIMER SETTING DURING OFF TIMER
SET
SET/
CANCEL
SET/
CANCEL
6
Model
COOLING CAPACITY
ELECTRICAL RATING
EER
MOISTURE REMOVAL
ROOM AIR CIRCULATION
DIMENSIONS
NET WEIGHT
GROSS WEIGHT
NOISE LEVEL
* Specifications are subject to change without notice for further improvement.
To reduce power consumption:
F
• Press ECONOMY.
hr
• To cancel this operation, press once
more.
When the air conditioner in operation:
F
Press the TIMER button.
hr
The SET/CANCEL indicator light will
blink awaiting for setting.
F
Press the TEMP/TIMER
hr
until the preferred hour of operation is
reached.
F
Press the SET/CANCEL button to
hr
complete the setting. At this time, the
SET/CANCEL indicator light is steady
instead of blinking.
NOTE
The hour reading will change back to the
set temperature reading after 10
seconds. (You can also revert to
temperature setting immediately by
pressing the TEMP/TIMER
buttons again.)
Press the TIMER button to check the
F
remaining programmed timer setting.
hr
The figure will be displayed for 10
seconds then will automatically switch
F
back to temperature setting.
hr
NOTE
The timer figure will change according
to the time remaining (if you set it to turn
off 3 hours from now, the timer will show
"2" at an hour later).
Press the SET/CANCEL button to cancel
F
the timer setting. The SET/CANCEL
hr
indicator light will turn off. However the
temperature remains displayed.
Phase
Frequency
Voltage
Current
Input
Height
Width
Depth
Indoor (Hi/Lo)
Outdoor (Hi/Lo)
SETTING THE ON TIMER
TIMER
TEMP/TIMER
SET
SET/
CANCEL
TIMER
TEMP/TIMER
SET/
CANCEL
CHECK TEMPERATURE/MODE/FAN SPEED
SETTING DURING ON TIMER
or button
TIMER
TIMER
or
CHANGE TEMPERATURE/MODE/FAN SPEED
SETTING DURING ON TIMER
SET
SET/
CANCEL
OPERATION
OFF/ON
SET/
CANCEL
TIMER
OPERATION
TIMER
CANCEL TIMER SETTING DURING ON TIMER
SET
SET/
CANCEL
OPERATION
OFF/ON
SET/
CANCEL
OPERATION
Btu/h
(Hz)
(V)
(Amps)
(W)
(Btu/W.h)
(Pints/h)
(Cf/min)
cm (inches)
cm (inches)
cm (inches)
kg (lb)
kg (lb)
dB (A)
dB (A)
When the air conditioner in operation:
F
Press the TIMER button. The TIMER
hr
indicator light will blink to await for setting.
Press the TEMP/TIMER
F
until the desired hour for operation is
hr
reached. Press the SET/CANCEL button
to complete the setting. At this time, the
F
TIMER indicator light is steady instead of
hr
blinking.
The display will show the remaining hour
F
hr to the start of the operation (if you set to
turn on 3 hours from now, the timer will
show "2" at an hour later).
When set time is reached, the air
conditioner starts the operation under the
previous setting mode and the TIMER
indicator will light off. Now, the previous
set mode and the fan speed will light up.
Simultaneously, the display will show the
setting temperature.
Press the TIMER button. The TIMER
F
indicator light will blink and the previous
hr
temperature setting will be shown.
Simultaneously, MODE and FAN
F
SPEED indicator will light up. This
hr
indication will last for 5 seconds, and
then the display will show the remaining
time. MODE and FAN SPEED indicator
light will turn off. At this time, the TIMER
indicator light is steady instead of
blinking.
Press the SET/CANCEL button to
F
cancel the timer setting.
hr
Press the OPERATION. Set the desired
mode and the fan speed. Then press
F
hr OPERATION button to stop operation.
Start the TIMER setting again by
F
repeating the step from the "Setting the
hr
on timer" procedures).
Press the SET/CANCEL button to cancel the
F
timer setting. The SET/CANCEL indicator
hr
light will turn off. To operate the air
conditioner before reaching the set timer:
F
• Press the SET/CANCEL to cancel the
hr
timer.
• Press the OPERATION button to turn on
the unit.
CW-XC103VU CW-XC123VU
10,000
Single
60
115
8.7
980
10.2
2.5
320
37.5 (14- 25 / ˝)
32
1
56 (22- / ˝)
16
27
60.6 (23- / ˝)
32
35 (77)
39 (86)
50/46
57/54
or button
11,500
+
+
+
9.8
1120
+
3.0
330
+
+
+
+
+
51/47
58/55