Usb Media Player Settings - Panasonic TH-84EF1U Operating Instructions Manual

Select [Save] and press <ENTER>.
Save the current network Setup.
Note
●
To use a DHCP server, make sure the DHCP
server is started.
●
Contact your network administrator for details on
[IP address], [Subnet mask] and [Gateway].
●
Shipping condition
[DHCP]: Off
[IP address]: 192.168.0.8
[Subnet mask]: 255.255.255.0
[Gateway]: 192.168.0.1
[Port]
Set the port number used for command control.
Select [Port] and press <ENTER> to set the number.
●
The available setting range is 1024 ‒ 65535.
●
Entering numbers (see page 53)
Note
● When the PJLink protocol is used, the port setting is
not necessary.
■
[Network status]
Checks the current Network settings status.
Network status
DHCP
IP address
Subnet mask
Gateway
MAC address
■
[AMX D. D.]
Set whether to allow the Display to be detected by AMX
Device Discovery.
[On]:
Enables detection by AMX Device Discovery.
[Off]:
Disables detection by AMX Device Discovery.
●
For more details, visit the following web site.
http://www.amx.com/
■
[Crestron Connected™]
When this function is set to [On], the Display can
be monitored or controlled via the network using
equipment and application software of Crestron
Electronics, Inc.
This Display supports the following application software
from Crestron Electronics, Inc.
RoomView Express
• ®
Fusion RV
• ®
RoomView Server Edition
• ®
54
English
Off
192. 168. 0. 8
255. 255. 255. 0
192. 168. 0. 1
12:34:56:78:9A:BC
[Crestron Connected™] is a function to connect to
a system developed by Crestron Electronics, Inc.
which manages and controls multiple system devices
connected to the network.
●
For details of "Crestron Connected™", refer to the
Crestron Electronics, Inc. web site (Provided only in
English).
http://www.crestron.com/
For the download of "RoomView
the Crestron Electronics, Inc. web site (Provided only
in English).
http://www.crestron.com/getroomview
■
[Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with and press <ENTER>.
Network settings
Reset
Yes No

USB media player settings

Set for USB media player function.
[USB media player settings] - submenu screen
USB media player settings
USB media player
Video playback mode
Resume play
Scenario file check
No scenario file
Slide show duration
■
[USB media player]
Set to enable or disable the USB media player
function.
■
[Video playback mode]
Sets the video playback mode.
If image disturbance occurs at the switching timing of
motion picture files during playback in the Standard
mode, switch to the Adjust mode.
[Standard]: Plays without a black image at the joint
between video files.
[Adjust]: Plays with a black image (approx. 2
seconds) inserted at the joint between
video files.
Note
●
The mode switching is enabled only when using the
single media player.
●
The display may be disturbed at the switching timing
of files during playback in the Standard mode.
Express", refer to
®
Enable
Standard
On
10 sec