Input Search - Panasonic TH-84EF1U Operating Instructions Manual

Input search

When a signal is not detected, another input with a
signal is automatically selected.
Select the item with
Select the set point with
Input search
Input search
1st search input
2nd search input
[Input search]
[Off]:
When there is no signal, the input is not switched
automatically.
[All inputs]:
Searches all inputs and switches to an input with
a signal.
Input search is executed in the following order.
(Example) When the current input is [HDMI1]
[HDMI2] → [DVI-D] → [PC] → [VIDEO] → [USB]
→ [HDMI1]
Note
● The inputs set to [(Skip)] in [Input label] (see page
47) are skipped when searching.
[Custom]:
Repeatedly searches [Current input], [1st search
input] and [2nd search input] in order, and switches
to an input with a signal.
[Input detection]:
Switches to the input where a signal is present by
monitoring the PC input and digital input.
Note
●
Set one of the following for the digital input for
[Detect digital input].
[HDMI1], [HDMI2], [DVI-D]
PC
16:9
Searching...
[Searching...] is displayed during the input search.
Note
●
When [Input detection] is set, [Input detection] is
displayed while monitoring the input.
58
English
.
.
Custom
(None)
(None)
[1st search input], [2nd search input]
Set the input to search when [Custom] is selected.
[HDMI1] / [HDMI2] / [DVI-D] / [PC] / [VIDEO] /
[USB] / (None)
[Detect digital input]
Sets the digital input to monitor during [Input
detection].
[HDMI1] / [HDMI2] / [DVI-D]
[Changing delay]
Sets the delay time until the input is switched during
[Input detection].
[Off]:
Switches the input if a signal is interrupted even for
a very short period.
1 ‒ 10:
Sets the delay time (sec.).
Switches the input when the set time has elapsed
after detecting no signal is present.
However, if the detection period during which no
signal is present is shorter than the set delay time,
the input is not switched.
Note
●
With the USB input, the unit determines no signal
is present when the USB memory is not connected
to the USB terminal.
In addition, even when a USB memory is
connected, if there is no playable file, the unit
determines no signal is present.
●
This menu will be greyed out and cannot be set
under the following conditions.
[Input lock] is not set to [Off]. (see page 59)
•
When [Setup] - [Image settings] - [No signal
•
image settings] - [Display setting] is set to [On].
(see page 49)
●
If the input is changed by this function, the last
input is selected when the power is turned on next
time.
If you wish to retain the original input when the
power is turned on, set [Initial input] to the original
input. (see page 59)
●
[Input detection] is the function that automatically
switches the input as below by monitoring the
presence of PC input signal and digital input signal.
This function is enabled when the displayed
•
input is the PC input or digital input set for
[Detect digital input].
Switches to the other input if no signal is
•
detected for the displayed input.
Also switches to the other input if no signal is
present for the displayed input when the power
is turned on or when the input is switched.
If a video signal is input to the input that is not
•
displayed (The status has changed from signal
absent to signal present.), the input is selected
and switched.