Network Settings - Panasonic TH-84EF1U Operating Instructions Manual

Network settings

Set when networking with a computer.
[Network settings] submenu will be displayed.
Network settings
Network control
Display name
LAN setup
Network status
AMX D. D.
Crestron Connected™
Reset
■
[Network control]
Set when controlling with the unit's LAN terminal.
[On]:
Controls via LAN using the LAN terminal of the
Display. The power indicator lights orange when
the power is turned off with the remote control
(standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
● When using the LAN control function for "Using
Network Function" (see page 64 ‒ 77), set this
function to [On].
■
[Display name]
The name of the Display that is shown on the network
can be changed.
■
[LAN setup]
Detailed network settings for the LAN established via
the LAN terminal of the Display can be configured.
Select [LAN setup] with
LAN setup
Save
DHCP
IP address
192.168.
Subnet mask
255.255.255.
Gateway
192.168.
Port
Off
EF1-00
Off
Off
and press <ENTER>.
Off
0. 8
0
0. 1
1024
--:--:--:--:--:--
[DHCP], [IP address], [Subnet mask], [Gateway]
Press to set [On] / [Off] of [DHCP] and press
<ENTER>.
When [Off] is selected, IP address and other settings
can be set manually.
[DHCP]:
(DHCP client function)
[On]:
Obtains an IP address automatically when a
DHCP server exists in the network the Display is
going to be connected.
[Off]:
When a DHCP server does not exist in the
network the Display is going to be connected,
set [IP address], [Subnet mask] and [Gateway]
manually.
[IP address]:
(IP address display and setting)
Enter an IP address when DHCP server is not
used.
[Subnet mask]:
(Subnet mask display and setting)
Enter a Subnet mask when DHCP server is not
used.
[Gateway]:
(Gateway address display and setting)
Enter a gateway address when DHCP server is not
used.
Note
● When [DHCP] is set to [On], the IP address, etc. will
be displayed in grey.
Entering numbers
IP address
I
192.168.
1. Select the address and press <ENTER>.
2. Select digits with
3. Change numbers with
4. Press <ENTER>.
You can cancel the change by pressing
<RETURN>.
0. 8
.
.
English
53