Settings For Print Forwarding - Epson TM-T20II-i Technical Reference Manual

Settings for Print Forwarding

To use print forwarding on this product, you need to register the print forwarding route using
EPSON TMNet WebConfig.
 You can use with TM-i firmware Ver.4.3 or later for this product.
 When using print forwarding, make sure you enable the spooler.
This section gives an overview of the setup procedure.
1. Connect this product to the network
Connect this product to the network and turn on the power.
2. Start EPSON TMNet WebConfig
On the setup computer, enter the following into the address bar of your Web browser to start EPSON
TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
For details, see "Starting EPSON TMNet WebConfig" on page
3. Set the Spooler
Enable the spooler settings, and then set the number of retry times and the retry interval. For details,
see "Settings for Spooler" on page
4. Set the Print Forwarding Route
Set the print forwarding route from [Print forwarding] on the [Web Service Settings] menu.
In [Message Text], set the notification message printed when print forwarding occurs, and then click
[Apply]. The settings for the forwarding message are saved to this product.
From [Print forwarding route to be registered], set the printer and location used for the print
forwarding route, and then click [Register]. The settings for the print forwarding route are saved to
this product.
After making each setting, click [Apply] or [Register]. Settings are not enabled unless you click
[Apply] or [Register].
For details, see "Web Service Settings - Spooler - Print forwarding" on page
70.
Chapter 2
92.
99.
Setup
2
71