Print Density; Print Speed; Interface Selection - Epson TM-T20II-i Technical Reference Manual

Print density

Selectable from levels 1 to 7 (85% ~ 115%).
Initial setting: level 4 (100%)
Depending on the paper type, it is recommended to set the print density as shown in the table
below for the best print quality.
Original Paper type
P350, AF50KS-E, KT55F20, KT48F20
F5041
When the print density level is increased, printing speed may be reduced.

Print speed

Selectable from levels 1 to 13 (Slow ~ Fast)
Initial setting: level 13
Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which may cause white lines due to
intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by
setting it lower, or set the transmission speed higher for the serial interface.
Character code table default
Selectable from 43 pages
Initial setting: Page 0 (PC437: USA, Standard Europe)
 For the character code table, see
 No settings are required.
International character default
Selectable from 18 sets
Initial setting: USA
 For the character code table, see
 No settings are required.

Interface selection

Interface is fixed.
Do not change the settings.
50
Density Level
4 (100%)
5 (105%)
"Character Code Tables" on page
"Character Code Tables" on page
145.
145.