Advertisement
FAULT FINDING
Remember, to recieve a clear satellite reception and picture, the dish must have the correct vertical
(elevation) and horizontal (azimuth) alignment.
1. I don't want to use the Sat Finder, can I turn it off?
Simply turn the knob fully to the left. Your sat finder will now be silent and just a green light will be
illuminated. Keeping it in-line doesn't affect your signal quality and uses very little power.
2. I can't seem to get my tripod flat using the level indicator.
This is only a guide. As long as your tripod is on relatively flat ground you should locate the right
satellite. If you are on a more uneven surface, this is ok, however, your elevation may
need to be different to the map in order to offset the uneven surface.
3. My Sat Finder has a high pitched tone but I have no picture.
You may have located a different satellite to the one your receiver is set to. E.g. If your receiver is set
to OPTUS C1 you may have located a different satellite. You will need to realign your dish. See page
16, adjust elevation and azimuth.
4. The dish unit doesn't seem to be dropping onto the tripod.
Ensure you rotation lock is not in the locked position. To do this you will need turn the knob
anti-clockwise.
5. I cant find any satellites in the zone I am limited to by the tripod.
Ensure the North leg is correctly positioned. This means it will be parallel to the North needle (white)
on the compass.
6. Will my satellite system work when pointing through trees and buildings?
Satellite, unlike TV signals, will not work through objects. The satellite dish must have a clear line of
sight to the satellite in the sky.
7. My dish unit does not rotate smoothly.
Ensure the Azimuth lock is fully released before rotating the system.
8. My system appears to have excessive movement between dish unit and tripod.
This is normal and required for rotation, however once you secure the azimuth lock, the system will
become stable and will not affect signal reception or quality.
9. I have noticed water inside my system, is this a problem?
The Precision kit has been designed for outdoor use. Therefore, it has been designed for water to
pass through the unit and exit easily. The system will dry out very quickly.
19
Advertisement
