Electrolux ETB4602AA User Manual page 24

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
TROUBLESHOOTING
Door operation
CONCERN
Freezer door pops open.
Self close not working.
Door not sealing properly
Door difficult to open and close
Automatic Ice maker system
CONCERN
Ice maker does not produce ice or not
enough ice
The icemaker is designed to produce a
tray of ice approximately every 3 hours,
depending on the conditions.
Ice has bad odour or taste
If you still require service
If you have a problem, and the problem persists after you have made the checks mentioned, contact your nearest
Electrolux approved Service Centre or the dealer you bought the refrigerator from. Be ready to quote the model number, the
9-digit PNC and 8-digit serial number, which is stated on the label inside the refrigerator compartment.
24
TROUBLESHOOTING
WHAT TO DO
This is normal and should re-close. This happens when the refrigerator door is
closed too quickly.
If the freezer door stays open, it indicates that the appliance needs to
be tilted backwards a little further. Refer to section "Installing your
new appliance".
Check if your appliance has self closing hinges as not all models do.
It indicates that the appliance needs to be tilted backwards a little further.
Refer to section "Installing your new appliance".
Ensure there is nothing that is preventing the door from closing such as
appliance contents or items placed near the appliance.
Ensure that the crisper/freezer bin is closed completely. Refit if required as
referred to in the section "Using your refrigerator".
Ensure the appliance is set up as per recommendations.
If the door is difficult to open just after you have closed it this is due to the
pressure equalising, the door will open normally after a few minutes.
WHAT TO DO
Ensure that the Ice Maker is switched on at the user interface refer to "About
the User Interface" for details.
Ensure water tank is full and contains clean water (if liquids other than clean
water have been used, call Electrolux Customer Care).
Ensure water tank is securely pushed into pump housing.
If the freezer compartment is too warm, refer to "freezer is too warm" then wait
24 hours for the freezer to reach ideal temperature.
Turn the unit off at the mains and leave for 2 minutes then turn the appliance
back on (this will reset the icemaker unit). Check for ice production after 24
hours.
Check that there is no obstruction under the ice maker and ensure the ice bin
is fitted correctly.
Cover food to ensure ice does not absorb foreign odours.
Interior of appliance or ice bin may require cleaning, refer to "Cleaning
your refrigerator".
Discard stale ice monthly and allow ice maker to produce a fresh supply.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ebe4500aaEbe5300aaEhe5220aaEte4600aaEtb5702aaEte5720aa

Table of Contents