La Crosse Technology WS-3610 Operation Manual page 5

Daylight Saving Time (DST) → ON/OFF. In setting "ON" the automatic change of the WWVB
Time Display from summer time to winter time and vice versa is activated. (Default DST ON).
Proceed with ‫٭‬NEXT‫.٭‬
WWVB Radio Controlled Clock (RCC) → ON/OFF. In setting "OFF" the clock is operating as a
normal Quartz clock (Default RCC ON).
12/24 hour Time Display Format (Default 12 h Format).
Note: In 12h format the hour is shown with « A.M » between midnight and noon, and « PM »
between noon and midnight.
Units
•
Temperature Display (Temp) in °F or °C (Default °F).
•
Wind Speed Display (Wind) in mph, km/h, m/s, knots or Beaufort (Default mph).
•
Rain Amount Display (Rain) in inch or mm (Default inch).
•
Air Pressure (Press) in inHg or hPa (Default inHg).
Relative Air Pressure (Rel. Pressure) → To be set to locally valid reference air pressure with
regard to the local height above sea level (Default 29.91 inHg).
Weather Tendency (Tendency) → Weather Tendency sensitivity in 3 steps of approx. 0.03 inHg
from 0.06 inHg to 0.12 inHg. (Default 0.09 inHg) In most cases the default works well; however
this should be set to 0.06 near the ocean and 0.012 in desert areas.
Storm Warning (Storm) → Storm Warning sensitivity in 7 steps of approx. 0.03 inHg from 0.09
inHg to 0.27 inHg. for storm warning display at a decrease of air pressure over 6 hours (Default
0.18 inHg).
Activate/Deactivate storm warning alarm with ‫٭‬ON‫٭ / ٭‬OFF‫( ٭‬Default ON).
Relearn Mode (Relearn Tx) → Allows the WS-3610 to relocate the outdoor transmitter (for
example after a battery change in the transmitter) without the necessity of a complete re-setup of
all system components → Acknowledge with ‫٭‬CONFIRM‫.٭‬
5