Page 1
Comet DECT User Manual & Warranty The energy-saving controller for your home network with FRITZ! Allows an individual heating program for each day! Ideal for FRITZ!Box Easy installation Silent operation www.eurotronic.org Heft-85x120mm-en.indd 1 Heft-85x120mm-en.indd 1 25.01.2016 15:52:11 25.01.2016 15:52:11...
Page 2
Comet DECT is designed for use in buildings. Operate Comet DECT only as described in the user manual. Comet DECT should only be put to use in a dry and Screw for dust-free place, away from direct sunlight. adapter Do not keep using the device when there is obvious damage.
Page 3
With Comet DECT you get a smart energy-saving Manual control buttons controller for the FRITZ!Box home network. Comet DECT can be easily set up via the FRITZ! Box and used - at home on your PC, Note-book or tablet, and on Confirmation...
Page 4
To prolong battery life, the display switches to the Perform the registration in the vicinity of your FRITZ!Box. Standby Mode after a few seconds. Pressing any 1. Insert the batteries into the unit Comet DECT. button wakes up the device. (Explanation can be found on page 7.) 2.
Page 5
Installation at the radiator ATTENTION For installation, Comet DECT must be in the INST positi- If the device is in Standby Mode, wake it up by pressing on. (Press button and with the setting wheel con- any key. The display flashes...
Page 6
Look at the help table. Set up and operate on the computer Once you logged in Comet DECT at the FRITZ!Box, you can set it up and operate it on the user interface of the FRITZ!Box. The user interface can be opened on any PC, laptop or tablet, which is connected to the FRITZ!Box.
Page 7
Holiday Mode Settings on the FRITZ!Box user interface For times when you are absent, you can specify a tempe- rature to which it is heated throughout. After the holiday period, the normal timer continues as set. Confirm with OK. Heating off Preset: 01.06.-31.08.
Page 8
Overview) you can adjust the current temperature. The temperature is maintained until the next change from Comfort to Economy temperature (or vice versa) Setting on Comet DECT that is dictated by the timer. The „temperature set“ may possibly differ from the „measured temperature“.
Page 9
MENU The frost protection function is activated automatically. the device. If the temperature drops below 6 °C, Comet DECT opens Manual temperature setting the valve until the temperature again rises above 8 °C. If, during operation, the target temperature is changed Thus, freezing of the heater is prevented.
Page 10
Un- Heimeier, Junkers Landy + Gyr, MNG, Honeywell, Brauk- screw the cap nut and remove Comet DECT off the valve. mann, as these have a thread of M30 x 1.5 mm. The adapt- ers for Danfoss RAV (pin must be plugged on the valve tappet) Danfoss RA and Danfoss RAVL are included.
Page 11
No adaptation Is the installation OK? Install Heating Valve does not Adapt again possible. Comet Comet DECT to the heater. element close com- (see “Adapting”) Move the DECT is not does pletely. It may valve stem several times...
Page 12
1995/5/EC. which are not mentioned above. The declaration of conformity according to the R&TTE guideline 99/5/EC can be found at www.eurotronic.org. Guarantee The three-year warranty begins on the day of purchase. Please keep the receipt as evidence of purchase in the future.
Need help?
Do you have a question about the Comet DECT and is the answer not in the manual?
Questions and answers