Installation Instructions - Danfoss TPOne-M Installation Manual

Installation Instructions

Specifications
Operating Voltage
Output 1 (Heating)
Setting temperature range
Operating temprature range
Switch rating 1
Switch type 1
Output 2 (Domestic Hot Water)
Switch rating 2
Switch type 2
IP rating
On/off control
Chrono-proportional control
Operating mode
Construction
Control pollution situation
Rated impulse voltage
Ball pressure test
Dimensions (mm)
Software Classification
ErP Class
The products represented within this document are classified according
to, and allow completion of, the Energy Related Product (ErP) Directive
System Package fiche and the ErP system data label. ErP Labelling
obligation is applicable from 26th September 2015.
ERP Class Product Function and ErP Description
TPI Room Thermostat, for use with on/off
IV output heaters
An electronic room thermostat that controls
both thermostat cycle rate and in-cycle on/
off ratio of the heater proportional to room
ErP
temperature. TPI control strategy reduces
mean water temperature, improves room
4
Product
temperature control accuracy and enhances
Class
system efficiency.
Danfoss Heating
TPOne-M
230Vac, 50/60Hz
Volt Free
5-35°C
0-45°C
3A (1) at 230Vac
1 x SPDT Type 1B
230Vac
3A (1) at 230Vac
1 x SPDT Type 1B
IP20
Yes
Yes
Heating
EN 60730-2-9
Degree 2
2.5kV
75°C
H67 x W154 x D30
A
Additional
efficiency
gain
2%
3