Preparing The Machine Before Installing The Hoop; Attaching And Removing Embroidery Hoop - Singer SEQS-6700 Instruction Manual

PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel counter clockwise (toward you) until the
needle comes to its highest position.
ATTACHING AND REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) of
under it.
To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
To remove, press the hoop release lever and slide the hoop
towards you.
NOTE: Before attaching the small hoop, turn on the power
switch to move the carriage to the ready position.
40
1
1
( A )
2
Carriage
Hoop mounting plate
Hoop release lever