Installation And Operation; Safety Instructions - Bartscher Contessa 1000 A190.041 Instruction Manual

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Never fill hot water into the cold water tank.
•
Do not fill water into the hot device; wait until it has cooled down.
WARNING! Hot surface!
During operation some elements of the device very become hot. To avoid burns,
do not touch hot elements!
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
- 25 -