Nt 14/1 Classic; Replacing The Mains Cable; Nt 14/1 Eco Te And Advanced - Kärcher NT 14/1 Service Manual

5.5.2 NT 14/1 Classic

1 Exhaust filter
2 Fastening screws for turbine housing
3 Power cord
4 Ferrit ring (anti-interference ring)
5 Power switch
6 Control chip
7 Suction turbine
8 Turbine casing
9 Cord grip
1 Control chip
2 Connecting cable, electrode overflow fuse
3 Connecting cable, suction turbine
4 Connecting cable, appliance switch

Disconnect all connecting cables from the circuit
board.

Remove the control printed circuit board from
holder.

Replace the circuit board.
10
English 5.906-492.0 Rev. 00 (12/10)

Connect the new circuit board as per the circuit di-
agram.

Insert the control printed circuit board into the
holder.

5.6 Replacing the mains cable

5.6.1 NT 14/1 Eco Te and Advanced

1 Ferrit ring (anti-interference ring)
2 Neutral conductor
3 Phase
4 Ground cable (protective conductor)

Unscrew the ground cable (protective conductor)
from the socket.

Disconnect the phase and the neutral connector
on the device switch.

Remove the clamp for mains cable.

Remove the mains cable from the cable guide.

Install the new mains cable in reverse sequence.
1
2
3
4