Martin MAC III AirFX User Manual page 56

Short code
PSER
PTCM
PTCO
PTCS
PTER
R1ER
SHNA
SHUE
SLER
SSTO
TIER
TINA
TSER
UECH
UECM
UECO
UEEF
UEPT
UEPU
UEUI
UEZF
UPLB
UPLC
UPLD
UPLD
UPLE
56
Full-text message
PAN SENSOR ERROR
PAN/TILT SENSOR CAL MISSING
The pan/tilt sensors are not calibrated.
PSU TEMP CUTOFF
Ballast in thermal cutoff
PAN/TILT CALIBRATE SENSOR (s/w versions prior to ver. 1.3)
Pan/tilt sensors not calibrated
PSU TEMP HIGH
The temperature on a PCB in the power supply unit or ballast is high. A fan might be defective or the
ambient temperature may be too high.
GOBO WHEEL ROTATION ERROR
SHUTTER NOT ADJUSTED
No shutter adjustment data in EEPROM
SHUTTER ERROR
SAFETY LOOP ERROR
Lamp safety loop circuit activated: the lamp access hatch is open or lamp is too hot
SYSTEM STATE TIMEOUT
Failure to communicate with module during self-check at startup. Service intervention required.
Fixture control possibly disabled, depending on nature of error.
TILT ERROR
TILT NOT ADJUSTED
Tilt needs to be adjusted by a qualified service technician.
TILT SENSOR ERROR
UPLOAD ERROR CHARGER
Could not upload new firmware to the Charger module.
UPLOAD ERROR CMY
Could not upload new firmware to the CMY module.
UPLOAD ERROR COOLING
Could not upload new firmware to the Cooling module.
UPLOAD ERROR EFFECT
Could not upload new firmware to the Effects module.
UPLOAD ERROR PAN/TILT
Could not upload new firmware to the Pan/Tilt Focus module.
UPLOAD ERROR POWER UNIT
Could not upload new firmware to the Power Unit module.
UPLOAD ERROR UI
Could not upload new firmware to the User Interface module.
UPLOAD ERROR ZOOM/FOCUS
Could not upload new firmware to the Zoom Focus module.
UPLOAD ERROR ON BALLAST (s/w versions prior to ver. 1.3)
UPLOAD ERROR ON COOLING (s/w versions prior to ver. 1.3)
DMX UPLOAD ERROR
An error occurred during upload via DMX. Check cabling and connections, and then restart.
DMX UPLOAD ERROR
Firmware upload via DMX failed.
UPLOAD ERROR ON EFFECT (s/w versions prior to ver. 1.3)
Table 5: Error messages
MAC III AirFX user manual