Martin MAC III AirFX User Manual page 52

Menu level 1 Menu level 2
PAN/TILT
FEEDBACK
ADJUST
SERVICE
CALIBRATION
UPDATE
FIRMWARE
EVENT LOG
52
Menu level 3 Menu level 4
On
Off
PAN/TILT
PAN/TILT AT
SENSOR
END STOP
CALIBRATION
CMY MODULE DIMMER
EFFECT MODULE SHUTTER
PAN
PAN/TILT
MODULE
TILT
DIMMER ... TILT
LOAD DEFAULTS?
SAVE FACTORY DEFAULT?
UPDATE
BANK
LOCATION
EVENT LOG TRIGGER
CLEAN EVENT LOG
Table 3: Control menus
MAC III AirFX user manual
Notes (Default settings in bold print)
Enable pan/tilt position feedback
systems
Disable pan/tilt position feedback
Move pan and tilt to end stops following
instructions in the display, then execute to
calibrate pan and tilt sensors
For use by qualified service technicians –
see Martin service documentation before
entering this menu
Set individual effects to calibration
positions (approx. +/- 5% offset available)
Load factory default calibration settings
Replace factory default calibration settings
with current calibration settings
Execute to update fixture firmware from
bank shown in display
Firmware bank version
Location of firmware bank
Triggers generation of event log
Clears event log and any current errors