Control Panel Menus - Martin MAC III AirFX User Manual

Control panel menus

Software version 1.0.0
Commands marked * can also be executed via DMX
Menu level 1 Menu level 2
Gives quick access to most frequently-used menus: FACTORY SETTINGS, DMX ADDRESS, PROTOCOL
SET, FIXTURE ID plus most frequently-used PERSONALITY settings: PAN/TILT SETTINGS, SPEED
SETUP WIZARD
SETTINGS, FANS, DIMMING CURVE, AUTOMATIC LAMP ON, DISPLAY. See table below for details of
these settings.
DMX ADDRESS 1 – 486
FIXTURE ID 0000 – 9999
PAN/TILT
SETTINGS
PERSONALITY
SPEED
SETTINGS
48
Menu level 3 Menu level 4
User-settable fixture ID number
SWAP
PAN INVERT
TILT INVERT
MOVE ON RESET
P/T LIMITATION
PAN MINIMUM
PAN MAXIMUM
TILT MINIMUM
PAN & TILT
LIMIT SETTINGS
TILT MAXIMUM
P/T LIMIT AREA
DEFAULT LIMIT
SETTINGS?
Normal
PAN & TILT Fast
SPEED
Slow
Follow P/T speed
Normal
EFFECT SPEED
Fast
Slow
Table 3: Control menus
MAC III AirFX user manual
Notes (Default settings in bold print)
DMX address (new fixtures are supplied
with address set to 1)
Map DMX pan control to tilt channel and
vice versa
Reverse DMX pan control: right → left
Reverse DMX tilt control: down → up
Enable/disable pan/tilt movement when
fixture resets. Default = On
Enable pan and tilt range limits
Set minimum pan angle (0° – 360°)
Set maximum pan angle (360° – 0°)
Set minimum tilt angle (-134° – 134°)
Set maximum tilt angle (134° – -134°)
Set pan/tilt to stay inside safe zone or stay
outside no-go zone (Inside/Outside)
Reset all pan and tilt limit settings to
factory defaults.
Normal speed pan and tilt
Optimize pan/tilt movement for speed
Optimize pan/tilt movement for
smoothness
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
Normal effects speed
Optimize effects movement for speed
Optimize effects movement for
smoothness