Connecting Power Supply - Hitachi CP-WU8700 User Manual

Connecting power supply

1.
Put the connector of the power
cord into the AC (AC inlet) of
the projector.
2.
Push the Cord Stopper until it is caught by
the hook.
3.
Firmly plug the power cord's plug into the
outlet. In a couple of seconds after the power
supply connection, the POWER indicator will
light up in steady orange.
Please remember that when the DIRECT
POWER ON function activated, the connection
of the power supply make the projector turn on.
WARNING
unit is attached to it.
►Please use extra caution when connecting the power cord, as incorrect or
faulty connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE • This product is also designed for IT power systems with a phase-to
phase voltage of 220 to 240 V.
►Do not connect the projector to a power supply while no lens
AC
Power
cord
Cord
Stopper
Setting up
Power
Cord
Hook
27