Parts Supplied; Cavity Preparation - Fisher & Paykel DishDrawer DD60S Series Installation Instructions Manual

(2,1) -1- 599683B DD60S installA2 NZGB.indd 6/7/09 11:36:09 AM
(2,1) -1- 599683B DD60S installA2 NZGB.indd 6/7/09 11:36:09 AM
4

PARTS SUPPLIED

Drain hose Drain hose
support (1) joiner (1)
If the Drain hose supplied is not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorised Service Centre or our local website listed at the end of this document.

5 CAVITY PREPARATION

These marks indicate formed bracket screw locations.
*
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose is routed straight into the waste connection.
Water Connection
Recommended COLD (Maximum 60°C).
¾ " BSP (GB20) to suit flat washer.
Water Pressure
Water softener models 1 MPa (145 psi)
Other models 1 MPa (145 psi)
Drains will need to be separated to satisfy kosher requirements.
We suggest you confirm acceptability with your local rabbi in
respect to kosher installations.
Wire clip (1) Clamp (1)
Max Min
0.1 MPa (14.5 psi)
0.03 MPa (4.3 psi)
Top mounting Phillips
brackets (2) 16 mm
screws (7)
OPTIONAL
Moisture
10 mm protection
tape must
be applied.
min. ø
60 mm
*
*
Important!
Adjacent cabinetry must not
extend above cavity base
Rubber Moisture protection
washer for tape (1)
inlet hose (1) (to prevent moisture
damage)
a t e d
n b e lo c
r v ic e s c a
N o t e : S e
.
D r a w e r ®
e o f D is h
e it h e r s id
max.
450 mm
Water supply
min.
200 mm
220-240 VAC
min. 4.5 A