Arturia beatstep pro User Manual page 50

Knob 1 will apply an offset to the values contained in the sequence. This offset will be
shown in the Value Display. The range is [-99 , +99].
Knob 2 will set the same value for all the active steps of your sequence as soon as you
turn the knob. The value will be shown in the Value Display.
For the DRUM sequencer, the changes will be applied to the currently selected drum
only.
Example 1:
Select SEQUENCER 1, set the length to 4 steps. Select the Velocity knob mode and
change the velocities of the four steps to 127 - 100 - 4 - 50
Now hold [SHIFT] and turn Knob 1.
The display will show you how much offset you applied. Turn Knob 1 until you get to a
value of 10.
The Velocity for the four steps should now be 127 - 110 - 14 - 60
Note: Velocity cannot go beyond 127 so when this value is reached, turning the knob to
the right or adding more offset will have no effect.
Example 2:
Select SEQUENCER 1, set the length to 4 steps. Select the Velocity knob mode and
change the velocities of the four steps to 127 - 100 - 4 - 50
Now hold [SHIFT] and turn Knob 2.
The display will show you the new value for the velocity of all steps. Turn Knob 2 until
you get to a value of 10.
The velocity for the four steps should now be 10 - 10 - 10 - 10
50 ARTURIA – BeatStep Pro – USER'S MANUAL