Brady BMP 61 User Manual page 163

Problem
Labels (Media) (continued)
Error - "No media installed"
Error - "No media installed"
Error - "No media installed"
Error - "Top of form"
Error - "Top of form"
Error - "Label and ribbon color
are identical"
®
BMP 61 Label Printer User's Manual
Replacing the Printer (Media Well) Cover
Cause
BMP71 labels/media are not
installed correctly.
Damaged circuit board on
label/media roll
Damaged contacts in receiver slot
of lower printer base.
Label/media or ribbon has caused
jam
Notch sensors in lower printer
frame are dirty. Notch Sensors in
the lower printer base need to
detect the prescence of the labels
to allow printer to operate
correctly.
Ribbon color and label color are
the same. Printing will not be
visible.
Internal Components
Corrective Action
1. Reinstall labels/media.
2. Press [CLEAR/ESC] key to
clear error.
See for proper
page 1-16
label/media loading. Verify that
circuit board on core of labels are
mating with contacts in receiver
slot of lower printer base.
1. Replace label/media roll.
2. Press [CLEAR/ESC] key to
clear error
Send to Brady for Repair
1. Clear any jams by opening the
printer cover and removing an
excess labels in the feed roller
or exit chute areas.
2. Press [CLEAR/ESC] key to
clear error.
1. Clean sensors in lower printer
base.
2. Press [CLEAR/ESC] key to
clear error.
(See page 7-1 for proper cleaning
techniques.)
1. Replace ribbon or
label/media.
2. Press [CLEAR/ESC] key to
clear error.
7-11