Important Safety Instructions - Weller PYROPEN WP 60 Operating Instructions Manual

To reduce the risk of injury or property damage, READ AND UNDER-
STAND the following warnings.
1. Do not fill gas or store near open flame, heater, furnace or combu-
2. Use only non-aromatic butane gas as recommended by the manu-
3. Be sure to put switch down after use.
4. Use only in open air place or well ventilated place.
5. Avoid dropping or causing a hard shock.
6. Do not use iron holder designed for the electrical iron. This may
7. Do not store under direct sunlight or anywhere that will exceed 40°C
8. Do not store near windshield, in trunk of car.
9. Keep out of reach of infants.
10. Keep hands and combustibles clear out of exhaust opening and tip
11. Do not immerse in water.
12. Do not try to disassemble or misuse or alter or tamper.
13. Do not wipe soldering iron with alcohol-based cleaner.
14. Cool down before putting protective cap on.
Ignition Instructions
1. Place gas control lever at the middle and push gas open switch up.
2. Push the knurled nut upward to open ignition holes.
3. Ignite keeping air take-in hole open as illustrated below. Hold knurled
4. Temperature of the soldering tip can be adjusted by moving gas
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

IMPORTANT SAFETY INSTRUCTIONS

stible materials.
facturer.
GB
cause burning of tool body.
or 140°F. This will cause fire / explosion as gas pressure become
high.
housing to avoid burns or fire.
HOW TO USE A SOLDERING IRON AND HOT BLOW
Exhaust opening
Ignition hole
Knurled nut
nut until glows the catalyst.
control lever between left / right.
Gas open Gas control
lever lever
ON OFF
19