Important Safety Instructions - Weller PYROPEN Operating Instructions Manual

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of injury or property damage, READ AND UNDERSTAND the following
warnings.
1. Check tools for damage before use.
2. If damage is found, the device must not be used and the tank must not
be refilled.
3. Do not fill gas or store near open flame, heater, furnace or combustible materials.
4. Use only non-aromatic butane gas as recommended by the manufacturer.
5. Be sure to put switch down after use.
6. Use only in open air place or well ventilated place.
7. Avoid dropping or causing a hard shock.
8. Do not use iron holder designed for the electrical iron. This may cause burning
of tool body.
9. Do not store under direct sunlight or anywhere that will exceed 40°C or 140°F.
This will cause fire / explosion as gas pressure become high.
10. Do not store near windshield, in trunk of car.
11. Keep out of reach of infants.
12. Keep hands and combustibles clear out of exhaust opening and tip housing to avoid
burns or fire.
13. Do not immerse in water.
14. Do not try to disassemble or misuse or alter or tamper.
15. Do not wipe soldering iron with alcohol-based cleaner.
16. Cool down before putting protective cap on.
17. Repairs are only to be performed by authorised specialist personnel.
18. Before taking soldering tools on board aircraft, always check the
applicable transport regulations specified by the airline company.
SPECIFICATIONS
Soldering tip or
hot blow tip
Hot air exhaust
hole *CAUTION:
Keep clear as
hot air comes
out here
Specifications
Lenght incl. soldering tip
Weight incl. gas filling
Temperature values
Burning time per gas filing
Filling quantity
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
Housing for sol-
dering tip or for Torch ejector
hot blow tip
Soldering
ejector
Kurled screw
Spanner
Ignition vent
OPEN/CLOSE knob
Control lever position 1 o 5 for adjusting
gas flow and so tip temperature and lame
lenght when tool is used as a torch
Gas-level window
Gas OPEN/CLOSE
main lever
242 mm (soldering and hot blow)
198 mm (torch)
105 g (soldering and hot blow)
95 g (torch)
About 200°C-500°C Soldering tip end
About 700°C max. at hot blow tip end
About 1.300°C max. at torch (burner)
About 11/2 - 4 hours
(soldering and hot blow)
About 50 minutes at max. gas flow (torch)
Te environmental temperature will slightly
influence the burning time
Max. 15 g
LP Gas Refill
Nozzle
Handle containing
butane gas
14