Product Overview; Getting Started; Inserting The Memory Card; Installing The Clip On Mirror Dvr - NanoCam Plus NCP-MIRDVRHD2 User Manual

1.3 Product Overview

1. USB/Rear Camera Input
2. Power Input (12V, DC)
3. Micro SD Card Slot
4. Power On/Off button
(Up) button
5.
6. (OK/Rec) button
7. (Down) button

2. Getting Started

2.1 Inserting Memory Card
With the Mirror DVR powered off and the screen facing towards you, insert
the memory card with the text on the micro SD card facing towards you.
Push the memory card in until a click is heard.
To remove the memory card
Ensure that the Mirror DVR is powered off, then push the memory card
until a click is heard and then release the card to eject.
Note:
1. Do not remove or insert the memory card while the Mirror DVR is turned on as this may
damage the memory card or corrupt the memory cards stored data.
2. Please use a Class 6 or higher rated micro SD card with a maximum capacity of 32GB.
3. Please format the Micro SD card before the initial use.
4. When removing the memory card, be careful as the card may eject quickly.

2.2 Installing the Clip On Mirror DVR

1. Loop the rubber fasteners over the top fastener clips.
2. Put the Mirror DVR in position on the front face of your existing rear view mirror ensuring that the camera lens clears the edge
of your rear view mirror.
3. Loop the bottom rubber fasteners over the bottom fastener clips.
6
8. (M) button
9. 5.0" IPS LCD Screen
10. Heat Dissipation / Air Flow
11. Fastening Clips
12. Wide Angle Lens
13. Speaker
14. Reset button