G Sensor; Park Mode; Photo Mode; Photo Menu - NanoCam Plus NCP-MIRDVRHD2 User Manual

2.7.6 G Sensor

The G Sensor defines the required force needed to trigger emergency recording. Once Emergency recording is triggered the
current recording will be saved and protected from being saved over by the normal loop recording. To set the required sensitivity
please follow the instructions below.
1. Press the
2. Press and hold the
3. Use the
4. Use the
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. If your memory card is filling up quickly you may need to lower the sensitivity of the G Sensor (Gravity Sensor) to decrease the number of triggers caused by
normal driving or other operations (eg., bumpy roads and opening and closing doors).

2.7.7 Park Mode

The Parking mode setting is used to activate a recording after you have parked your vehicle. To adjust the key beep settings,
follow the instructions below.
1. Press the
2. Press and hold the
3. Use the
and OFF.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.

3. Photo Mode

This screen is used to capture images using your Mirror DVR.
To access the Photo screen ensure that the camera is not recording and short press the
will change to a camera.

3.1 Photo Menu

3.1.1 Image Quality

Image Quality sets the resolution for the photos taken by the Mirror DVR. Higher resolution image will capture more detail
and will also produce larger files. To change the image quality, please follow the instructions below.
1. Press the
12
button to stop the Mirror DVR from recording.
Button for 2 seconds to enter the Menu.
and buttons to navigate the Menu and highlight the G Sensor setting and press
and buttons to highlight your desired sensitivity, then press the
button to stop the Mirror DVR from recording.
Button for 2 seconds to enter the Menu.
and buttons to navigate the Menu and highlight the Park Mode setting and press
button to stop the Mirror DVR from recording.
to select.
button to confirm your selection.
to switch the setting ON
button. The icon in the top left of the screen