White Balance; Exposure - NanoCam Plus NCP-MIRDVRHD2 User Manual

2. Press and hold the
3. Use the and
4. Use the and
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.

3.1.2 White Balance

The White Balance setting is used to manually adjust the settings used to counteract different light conditions. This setting is
set to Automatic by default. To change the White Balance setting follow the instructions below.
1. Press the button to stop the Mirror DVR from recording.
2. Press and hold the
3. Use the and
4. Use the and
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.

3.1.3 Exposure

Exposure is used to manually control the light settings. To change the Exposure setting follow the instructions below.
1. Press the button to stop the Mirror DVR from recording.
2. Press and hold the
3. Use the and
4. Use the and
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
Button for 2 seconds to enter the Menu.
buttons to navigate the Menu and highlight the Image Quality setting and press
buttons to highlight your required image resolution, then press the
Button for 2 seconds to enter the Menu.
buttons to navigate the Menu and highlight the White Balance setting and press
buttons to highlight your required White Balanee setting, then press the
Button for 2 seconds to enter the Menu.
buttons to navigate the Menu and highlight the Exposure setting and press
buttons to highlight your exposure setting, then press the
to select.
button to confirm your selection.
to select.
button to confirm your
to select.
button to confirm your selection.
13