Rear-Wheel Stand - BMW R 1200 S Rider's Manual

Mounting front wheel
stand
Place motorcycle on an
auxiliary stand; BMW Mo-
torrad recommends BMW
Motorrad rear wheel stand.
Loosen adjusting screws 1.
Push two mounting pins 2
far enough apart that front
forks fit between them.
Use locating pins 3 to set
front wheel stand to desired
height.
Center the front wheel stand
relative to the front wheel
and push it against the front
axle.
Push two mounting pins 2
through triangles of brake
caliper support toward in-
side so that front wheel can
still be rolled through.
With BMW Motorrad
ABS, the ABS sensor
ring can be damaged.
Only push the mounting pin
so far inward that it does not
touch the sensor ring of the
BMW Motorrad ABS.
Tighten adjusting screws 1.
Apply uniform pressure to
push the front wheel stand
down and raise the motor-
cycle.

Rear-wheel stand

Rear- wheel stand
In order to be able to work
safely on motorcycles without
center stands, BMW Motor-
rad offers a rear wheel stand.
This rear wheel stand with
the BMW special tool num-
ber 36 3 980 can be obtained
from your authorized BMW
Motorrad retailer.
7
99
z