Honda 08L96-TA0-100 Installation Instructions Manual page 6

22. While wearing eye protection, drill a 6.5 mm hole at
each marked position. First drill with a 3 mm bit, and
finish with a 6.5 mm bit. Remove any burrs from the
edge of the holes using a round file.
DRILL
TRUNK REAR TRIM PANEL
23. Install the four small anchors to the trunk rear trim
panel using one 6 x 16 mm hex bolt, one 6 mm
spring washer, and one 6 mm plain washer for each
anchor. Torque the 6 x 16 mm hex bolts to 5 N·m (3.7
lb-ft). Position each anchor horizontally as shown.
4 HEX BOLTS, 6 x 16 mm
Torque to 5 N·m
(3.7 lb-ft).
TRUNK REAR TRIM
24. Reinstall the trunk rear trim panel (four clips and
three hooks).
6 of 7
DRILL BIT
(3 mm 6.5 mm)
4 SPRING
WASHERS, 6 mm
4 PLAIN
WASHERS, 6 mm
4 SMALL
ANCHORS
Installing the Cargo Net
Vertical Position: Hook the loops on the cargo net
around the anchors.
LARGE ANCHOR
SMALL ANCHOR
7220120E
SMALL
ANCHOR
722013BE
AII 42259 (0908)
LOOP
CARGO NET
LOOP
LARGE ANCHOR
SMALL ANCHOR
LOOP
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
740232BE