Advertisement
14. Reinstall the left and right trunk side trim panel (five
clips for each panel).
15. Thread one small anchor with spacer into the upper
rivet nut, and install one small anchor without spacer
into the lower rivet nut. If the anchors are positioned
vertically, turn them to the horizontal position.
Position the anchors
horizontally.
LEFT TRUNK
SIDE TRIM PANEL
RIVET
NUT
SMALL ANCHOR
(without spacer)
16. Thread one large anchor onto the 6 x 16 mm hex
bolt. Position the anchor horizontally.
17. Repeat the steps 15 and 16 to install anchors on the
right trunk side trim panel.
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
TRUNK
RIVET
LID
NUT
HINGE
SMALL
ANCHOR
(with spacer)
LARGE
ANCHOR
HEX BOLT,
6 x 16 mm
722009CE
AII 42259 (0908)
18. Attach template A to the back of the trunk rear trim
panel using masking tape.
TEMPLATE
PUSHPIN
REAR TRIM PANEL
Align with the rib.
19. Using a pushpin, mark the back of the trunk rear trim
panel according to template A. Remove the
template.
20. Turn the template over and attach it to the left side of
the trunk rear trim panel using masking tape.
PUSHPIN
TEMPLATE
Align with the rib.
TRUNK REAR TRIM PANEL
21. Mark the rear trim panel the same way. Remove the
template.
REAR TRIM PANEL
MASKING
TAPE
TEMPLATE
MASKING
TAPE
MASKING TAPE
MASKING
TRUNK REAR TRIM
TAPE
PANEL
MASKING
TAPE
TEMPLATE
MASKING
TAPE
MASKING
TAPE
7220100E
7220110E
5 of 7
Advertisement
