LEFT TRUNK
SIDE PANEL
15 ~ 20 mm
CLIP HOLE
6.
Install one rivet nut into each enlarged hole:
•
Thread the rivet nut onto the mandrel of the rivet
tool as shown.
RIVET NUT
TOOL
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
TRUNK LID
HINGE
CLIP HOLE
DRILL BIT
(9 mm)
DRILL BIT
TAPE
RIVET
NUT
MANDREL
•
Insert the rivet nut into the hole in the left trunk
side panel, and install the hex wrench.
LEFT TRUNK
SIDE PANEL
DRILL
740230CE
•
While holding the rivet nut tool with the hex
wrench, use a 19 mm wrench to rotate the tool in
a clockwise direction until the rivet nut is fully
collapsed.
2 RIVET NUTS
771013AE
RIVET NUT
•
Remove the tool from the rivet nut by turning the
hex wrench counterclockwise.
•
Repeat these steps to install a rivet nut in the
lower hole in the left trunk side panel.
AII 42259 (0908)
LEFT TRUNK
2 RIVET NUTS
SIDE PANEL
RIVET NUT
LEFT TRUNK
SIDE PANEL
LEFT TRUNK
SIDE PANEL
TRUNK
LID
HINGE
2 RIVET NUTS
RIVET NUT
TOOL
HEX
WRENCH
722006CE
RIVET
19 mm
NUT
WRENCH
TOOL
HEX
WRENCH
722007CE
3 of 7