Advertisement
7.
Insert one 6 x 16 mm hex bolt into the hole in the left
trunk side panel, and install two 6 mm plain washers
and a 6 mm flange nut. Torque the 6 x 16 mm hex
bolt to 9.8 N·m (7.2 lb-ft).
HEX BOLT, 6 x 16 mm
Torque to 9.8 N·m
(7.2 lb-ft).
LEFT TRUNK
SIDE PANEL
HOLE
8.
Install a 6 x16 mm hex bolt to the hole in the right
side panel the same way.
9.
Using a pushpin, pierce the center of the circle of
dots on the inside of the left trunk side trim panel.
DRILL
DRILL BIT
(3 mm
11 mm)
PUSHPIN
10. While wearing eye protection, drill at the pierced
mark to 11 mm. First drill with a 3 mm bit, and
finish with an 11 mm drill bit.
11. Repeat steps 9 and 10 to mark and drill the right
trunk side trim panel.
4 of 7
FLANGE NUT,
6 mm
2 PLAIN
2 PLAIN
WASHERS
WASHERS,
6mm
6 mm
LEFT TRUNK
SIDE TRIM
PANEL
MARK
722004CE
12. Assemble four small anchors.
13. Install a spacer on the two of the assembled
anchors. Note the direction of the spacer.
SPACER
AII 42259 (0908)
SMALL ANCHOR
STUD BOLT
SMALL ANCHOR
STUD BOLT
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
761811AE
740231AE
Advertisement
