Replacing The Fuse - Yamaha YBR125ED Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
turned to "OFF", then discon-
nect the negative lead before
disconnecting the positive lead.
[ECA16303]
2. If the battery will be stored for
more than two months, check it at
least once a month and fully char-
ge it if necessary.
3. Fully charge the battery before
installation. NOTICE: When in-
stalling the battery, be sure the
key is turned to "OFF", then
connect the positive lead before
6
connecting the negative lead.
[ECA16841]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.

Replacing the fuse

The fuse is located behind panel B.
(See page 6-7.)
To access the fuse, disconnect the
starter relay coupler.
1. Starter relay coupler
ECA16531
2
1. Fuse
2. Starter relay holder
3. Starter relay
6-29
The spare fuse is located on the rear of
EAU43214
the starter relay holder.
To access the spare fuse, remove the
starter relay (together with its holder)
by pulling it out, then turn the starter re-
lay over.
1. Spare fuse
2. Starter relay holder
3. Starter relay
1
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
3
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
3
1
2