Shifting - Yamaha YBR125ED Owner's Manual

3. Start the engine by pushing the
start switch or by pushing the
kickstarter lever down.
If the engine fails to start when us-
ing the start switch, release it, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt. If the engine does
not start with the starter motor, try
using the kickstarter.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
OPERATION AND IMPORTANT RIDING POINTS

Shifting

1. Shift pedal
2. Neutral position
ECA11043
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
EAU16672
NOTICE
 Even with the transmission in
 Always use the clutch while
5-2
the neutral position, do not
coast for long periods of time
with the engine off, and do not
tow the motorcycle for long dis-
tances. The transmission is
properly lubricated only when
the engine is running. Inade-
quate lubrication may damage
the transmission.
changing gears to avoid dam-
aging the engine, transmission,
and drive train, which are not
designed to withstand
shock of forced shifting.
ECA10261
5
the