Quick Start - Aetertek AT-211SW User Manual

Quick Start

a:Press and hold
on On/Off
button until the
RED LED light
stay in
solid.
5
Step 5:
Match the receiver and transmitter. Choose the
dog mode (Dog1, dog2 or dog00) by pushing the M button .
For the first receiver, choose dog 1 and quick press one of the
three buttons on the front , the first receiver will be connected
with the remote along with red light turns off and blue light
starts flash. If you have another receiver, turn it on and choose
dog 2, press any fuction buttons. The second receiver will be
paired; You can train different dogs separately in different dog
system. If Dog00 is selected, both dogs will receive
correctional signals.
Shock Button
Beep Button
6
-03-
b:Press down Shock,
Beep or Vibrate button,
receiver will be synced
with transmitter.
Vibrate Button
Step 6:
Check the button function. Push the beep button,
the receiver will produce beeping sound and similarly, push the
vibrate button, it will cause vibration. Cap the shock test kit on
the metal prongs and push the shock button. If the bulb lights
up, the shock function is ok.
Push up M button will increase shock
Shock Level
level;
push down M button will reduce shock
level;
7
Step 6:
Press the M button up or down to increase or
decrease shock level. There are 10 available levels.
Tip 4: Longer(shorter) holding beep, vibrate or shock button will
lead to longer (shorter) duration of beep, vibrate or shock time.
Step8:
Start to train. Put the collar into the receiver and wear
the receiver around dog's neck. Remember to leave one finger
place between collar and neck, then it's ready to train.