Quick Start - Aetertek AT-215 Owner's Manual

Quick Start

1
2
3
-02-
Step 1:
Screw the
antenna tightly onto the
transmitter.
Step2:
Open the
transmitter's battery cover,
and install the 9V battery
into the transmitter. Match
the + and - on batteries to
the diagram inside
Step 3:
Screw in the
appropriate metal prongs
onto the receiver till
securely attached.
Charge port
Blue LED light
Red LED light
4
Tip 1: Recommend to charge the receiver up to 3 hours for the first 3 times .
A:Press and hold on On/Off
button until
the Red LED
light stay in
solid.
5
On/Off Button
Step 5:
Match the receiver and transmitter. If you just
finished charging, please push any of the function button
(shock, beep, vibrate) immediately on the transmitter. If
not, you need to turn on receiver by holding on On/Off
button until the Red LED light stay in solid. Once the
receiver and transmitter matched, the Red LED light turns
off and the Blue LED light flashes every 10 seconds.
Tip 2: If the receiver is already matched with the transmitter before , after
unplugging the charger , the RED LED won't light up which means user
don't need to pair the receiver with the transmitter any more .
Step 4:
Charge the receiver.
A Red LED light of the receiver
will turn on during charging .
When done, the Blue LED will
light up. Once you unplug the
charger, the Red LED light will
stay on solid-waiting for sync,
at the same time, the Blue LED
light will go off.
b:Press down Shock,
strong Shock or
Vibrate button,
receiver will be
synced with
transmitter.