Page 1
User's Manual for Dog training colla AT-216 www.aetertek.com AT-216...
Page 2
Buyer assumes all risks and liability from the use of this product. 5. Modification of Terms and Conditions Aetertek reserves the right to change the terms, conditions, and notices under which this product is offered. For parts and warranty, contact with authorized dealer shown in warranty card...
Quick Start Super Remote Dog Trainer Step 4 Charge the receivers. Step 1 Install the antenna onto the transmitter. Make sure the A RED LED light of the receiver is on during charging. When antenna is securely attached. charging is over, the red LED light will be off with the BLUE LED light on.
Page 6
Quick Start Step 6: Check the Function buttons (beep, vibrate, shock) Step 8 Choose the dog mode(Dog1, or Dog2, or Dog3) Push the Beep button or Vibrate button, the receiver will produce Push the Dog Switch button in the left of the transmitter to beeping sound or vibration.
Page 14
Warranty, Terms & Conditions, Super Remote Dog Trainer Compliance(continued) Aetertek -12-...
Page 15
Buyer assumes all risks and liability from the use of this product. 5. Modification of Terms and Conditions Aetertek reserves the right to change the terms, conditions, and notices under which this product is -13-...
Page 16
This equipment has been tested and found to comply with the limits for a Class B digital device, pur suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate ra dio frequency energy and, if not installed and used in accordance with the instructions, may cause h armful interference to radio communications.
Need help?
Do you have a question about the AT-216 and is the answer not in the manual?
Questions and answers