Quick Start - Aetertek AT-919A Owner's Manual

Quick Start

1
Tip 1: It is recommend to charge the trainer for up to 8 hours for the first 3 times.
3
ON/OFF area
Step 3:
To turn on/off the trainer, just make the magnet touch the magnet switch on the trainer until the
trainer vibrates. The red and blue lights will flash once and the
Tip 2: To do a self-test, place the magnet near to the ON/OFF area on the trainer for 3 times, and the trainer will beep, vibrate or shock with the
blue light on, indicating the trainer works normally.
-03-
Step 1:
Screw the metal
prongs onto the trainer till
the prongs are securely
attached. Normally, they
are assembled in the factory.
Place the magnet near to the magnet switch
on the trainer until the
red light will be on, indicating that the
is started. Just repeat the above steps to turn
off this trainer.
2
trainer vibrates. The
trainer
trainer
Step 2:
Charge the trainer. Lift the
small rubber tab on the trainer to access
the charging port. Plug the wall charger
into the wall socket and into the charging
traine
port of the r. A red led light will
be visible on the trainer during the
charging process.
will beep.