Quick Start - Aetertek AT-918 Owner's Manual

Quick Start

1
2
3
-02-
Step 1:
Screw the
antenna tightly onto
the transmitter.
Step 2:
Charge the
transmitter. The signal
light will flicker until
battery is fully
charged.
Step 3:
Screw the
appropriate metal
prongs onto the
receiver till securely
attached.
4
Tip 1: Recommend to charge the transmitter and receiver up to 3
hours for the first 3 times
a:Press and hold
on On/Off button
until the Red LED
light stay in solid.
5
Step 5:
Match the receiver and transmitter. If you just
finished charging, push any of the function buttons (shock,
beep, vibrate)immediately on the transmitter. If not, you need
to turn on the receiver by holding on the On/Off button until
the Red LED light to be solid. Once the receiver and transmitter
matched, the Red LED light turns off and the Blue LED light
flashes every 10 seconds.
Tip 2:After 3 minutes of inactivity, transmitter will go into sleep
mode. You can wake it up by pressing any function keys(Vibrate,
Shock and Beep).
Step 4:
Charge the receiver. A
Red LED light of the receiver is on
while charging . When charging is
over, the Blue LED will light up.
Once you unplug the charger, the
Red LED light will stay in
solid-waiting for sync, at the same
time, the Blue LED light will go off.
b:Press down Shock,
Beep or Vibrate button,
receiver will be synced
with transmitter.