Quick Start - Aetertek AT-211SW User Manual

Quick Start

power
1
remained icon
2
3
Step 1:
Charge the
transmitter. The power
remained icon will move
from low to high to indicate
charging process.
Step 2:
Screw the metal
prongs onto the receiver till
securely attached. (Normally it
was assembled already
in the factory. )
Step 3:
Charge the receiver.
A Red LED on the receiver
will turn on during charging .
When charging is over, the
Blue LED light will light up.
Once unplugged, the Red LED
will stay in solid-waiting for
sync, at the same time, the
Blue LED light will go off.
Tip 1: Recommend to charge the receiver up to 3 hours for the
first 3 times.
Tip 2: To do a self-test, press the On/Off button of receiver three
times it should beep, vibrate and shock, indicating a functional
unit.
Dog 0,1 or 2 Icon:
0 means both dogs;
1 means the 1st dog;
2 means the 2nd dog.
4
Step 4:
Turn the remote on by pushing any function
buttons (Shock, beep and vibrate). Choose the dog mode
(dog 1, dog 2 or dog 0). Quickly press M button time by
time will choose 0, 1, or 2 dog you want to train. If Dog0 is
selected, both dogs will receive correctional signals.
Tip 3:After 3 minutes of inactivity, transmitter will go into sleep
mode. You can wake it up by pressing any function keys
(Vibrate, Shock and Beep).
M Button
Quick press one by one
time will choose 0,1 or 2
dog system;
-02-