Quick Start - Aetertek AT-215D Manual

Quick Start

1
2
3
Step 1:
Screw the antenna tightly
onto the transmitter.
Step2:
Open the transmitter's
battery cover, and install the 9V dry
battery into the transmitter. Match
the + and - on battery to the diagram
inside.
Step 3:
Screw the metal prongs onto the
receiver till the prongs are securely attached.
Normally, they are assembled in the factory.
4
Tip 1: Tip 1: It is recommend to charge the transmitter and receiver for up to 3 hours
for the first 3 times.
Place the magnet on the
transmitter near to the
magnet switch on the
receiver until the receiver
vibrates. The red light will
be on, indicating that the
receiver is started.
ON/OFF area
5
Step 5:
Turn the receiver on/off. Bring the magnet on the
transmitter near to the magnet switch on the receiver until
the receiver vibrates. At that time, the red light will be on/off,
indicating that the receiver is started/off. If you just finish
charging, unplug the charger, and the receiver is on already.
Tip 2:
To do a self-test, place the magnet on the transmitter near to the
ON/OFF area on the receiver for 3 times, and the receiver will vibrate or
shock with the blue light on, indicating the receiver works normally.
Step 4:
Charge the receiver. The RED
LED light of the receiver will be on while the
receiver is charging. When the receiver is
fully charged, the BLUE LED will be on. Once
you unplug the charger, the RED LED light
will stay solid on-waiting for sync. At the
same time, the Blue LED light will go off.
-02-