Data Plate - Hotpoint FZ G /HA Operating Instructions Manual

There is an adjustable L-shaped pipe fitting on the
GB
appliance supply ramp and this is fitted with a seal in
order to prevent leaks. The seal must always be
replaced after rotating the pipe fitting (the seal is
provided with the appliance). The gas supply pipe
fitting is a threaded 1/2 gas cylindrical male
attachment.
Connecting a flexible jointless stainless steel
pipe to a threaded attachment
The gas supply pipe fitting is a threaded 1/2 gas
cylindrical male attachment.
These pipes must be installed so that they are never
longer than 2000 mm when fully extended. Once
connection has been carried out, make sure that the
flexible metal pipe does not touch any moving parts
and is not compressed.
! Only use pipes and seals that comply with current
National regulations.
Checking the tightness of the connection
! When installation has been completed, check the
pipe fittings for leaks using a soapy solution. Never
use a flame.
4

DATA PLATE

width 43.5 cm
Dimensions
height 31 cm
depth 43.5 cm
Volume
58 l
This appliance conforms to the
following European Economic
Community directives:
2006/95/EEC dated 12/12/06
(Low Voltage) and subsequent
amendments - 2004/108/EEC
dated 15/12/04 (Electromagnetic
compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent
amendments. 2009/142/EEC
dated 30/11/09 (Gas) and
subsequent amendments.
2002/96/EC and subsequent
amendments.