Adjusting The Self-Propel Drive; Replacing The Blade - Lawn-Boy 10666C Operator's Manual

Figure 46

Adjusting the Self-propel Drive

If your mower does not self-propel properly, adjust the
self-propel drive cable.
1. Loosen the nut on the cable mount (Figure 47).
Figure 47
1. Cable mount
2. Pull the upper handle back fully rearward.
Note: If the handle does not move smoothly, refer
to Lubricating the Upper Handle.
3. Pull the cable jacket downward until you remove the
slack in the exposed cable (Figure 48).
1. Exposed cable
4. Push the cable jacket upward 1/8 inch (3 mm).
Note: You can place a ruler against the upper side
of the black cable mount and measure how far the
upper end of the cable jacket moves (Figure 49).
1. Cable mount
Note: Moving the cable jacket upward decreases
the ground speed; moving the jacket downward
increases the ground speed.
5. Tighten the nut firmly.
6. Start the mower and check the adjustment.
Note: If the self-propel drive is not properly
adjusted, repeat this procedure.

Replacing the Blade

Service Interval: Yearly
Important:
You will need a torque wrench to install
the blade properly
. If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If
the blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened or
replace it.
19
Figure 48
Figure 49
2. Cable jacket